How to mark your gear using electroetching

[TJuhler]

Hi guys.

Just made this small video on how to mark your gear using electro etching.

It can be used for titanium, brass, copper, steel, metal, etc....

Hope you can use it, otherwise I will take it down.

Thomas

 

[Bushman16]

Wow, that is brilliant. What a great way to enhance and personalise your equipment. Thank you for sharing.

 

[Joecole]

Hi guys.

Just made this small video on how to mark your gear using electro etching.

It can be used for titanium, brass, copper, steel, metal, etc....

Hope you can use it, otherwise I will take it down.

Thomas

Please go to the introduction section and tell us a bit about yourself Thomas

 

[TJuhler]

Please go to the introduction section and tell us a bit about yourself Thomas

I will

 

[Joecole]

I will

Thank you

 

[Chalkflint]

Hello Thomas
Great video.
I have used a very similar process for putting identity markings on test equipment.
This was before the days of laser printers and we used to just stamp the numbers into the paper or use an old typewriter and then etch it on.
Welcome to the forum
Clive

 

[TJuhler]

Hello Thomas
Great video.
I have used a very similar process for putting identity markings on test equipment.
This was before the days of laser printers and we used to just stamp the numbers into the paper or use an old typewriter and then etch it on.
Welcome to the forum
Clive

Wow, that sounds awesome. Experimenting and difficult
Today PnP paper makes it easy, and you can make whatever pattern you want from time to time

 

[TJuhler]

Heres is a few of my knives where I have used etchings

Thomas

 

[Henre]

Heres is a few of my knives where I have used etchings

Thomas

Did you make the knives too? They're awesome

 

[TJuhler]

Did you make the knives too? They're awesome

Yes, I made those knives from O1 steel using stockremoval.

Thank you

Thomas